Since this is one continuous line (i.e., the printhead never leaves the print surface), I would think that I could crank the heat without stringing, right? That said, I'm already printing at 200c, so I don't have a lot more room to go before I start to burn the PLA. I'll poke at this though.
I haven't played with different extrusion amounts at certain points (only over/under extruding for the whole print). I'll have to check that out too.
I've considered a build chamber, but it's pretty far down my todo list. Why does that option suck? Just the amount of work involved compared to the first two options?
