Reply to thread

Message

Nice! Looking good. I always had trouble with the smaller text too. Not sure why exactly I could do all the little qr code dots perfect, but the lettering I would get the same issue with under extrusion. Bolding it might help a bit, and maybe setting your retraction extra prime amount up a little. I've been using 0.1mm³ and noticed it helps a bit after a series of a lot of small retractions. It may over extrude a bit if you don't have many retractions and the travels aren't as far though.

[QUOTE="DrNezbit, post: 382, member: 10"] Nice! Looking good. I always had trouble with the smaller text too. Not sure why exactly I could do all the little qr code dots perfect, but the lettering I would get the same issue with under extrusion. Bolding it might help a bit, and maybe setting your retraction extra prime amount up a little. I've been using 0.1mm³ and noticed it helps a bit after a series of a lot of small retractions. It may over extrude a bit if you don't have many retractions and the travels aren't as far though. [/QUOTE]

Verification